BMW M50 M52
ENGINES SINGLE VANOS OIL SEAL REPAIR KIT
Warning: Last items in stock!
The vanos unit is designed to vary the the engine intake and exhaust valve timing to help improve engine performance.
Inside the vanos unit there are 2 pistons and in each piston there are four seals. The seals over time leak oil due to deterioration with the manufacturers seals, which in turn causes the vanos unit to perform poorly and effect engine performance.
The OEM o-rings are made from Buna, a material that is not suitable to withstand the higher temperatures found in automotive engines. As the piston seals are removed the OEM o-rings can be found to be extremely hard and in some cases splitting.
It is not possible to purchase individual seals from BMW, instead they supply either brand new Vanos units or reconditioned vanos units. However both come with the same weaker buna o-rings which will lead to vanos seals failure in the near future again.
These can be fitted by any competent mechanic or DIY- er. There are no special tools required other than a waterpump pulley holding tool which can make life easier...however a mallet and some force can be used instead..
Poor or lumpy idling.
Poor torque low down the rev range. Loud ticking noises coming from the Vanos unit. Louder idle, increase fuel consumption and poor cold weather starting.
Any P fault code relating to the vanos unit or exhaust valve cams.
I6automotive has manufactured a cost effective solution.
The long term solution is to use our 'Vanos Seal Kit' to replace the OEM Buna o-rings with Viton o-rings which are more commonly found in the automotive industry and are able to withstand the environmental affects within the vanos units better. This along with our custom manufactured PTFE rings make sure that your performance is factory restored and will last the LIFETIME of the engine, not the manufacturers warranty period.
X1 Single Vanos seals repair kit